Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Repair for Bushwick Homeowners
Brick in Bushwick takes a beating. The neighborhood’s older rowhouses and converted multi-families sit through humid summers and hard freezes, and a chimney that was sound a few winters ago can start shedding mortar joints without any warning from inside the house. When you notice a crumbled joint, a loose brick, or water staining on the chimney breast, you’re looking at repair territory, and small repairs are far cheaper than the rebuild they lead to if you wait.
Our technicians have up to 10 years of experience with exactly this kind of masonry and flue work. We handle every part of the system ourselves, from mortar repointing to HeatShield flue resurfacing to full chimney rebuilding. We diagnose before we recommend, always: an inspection comes first, and nothing gets proposed until you’ve seen the evidence. We dispatch Sunday through Friday, 7am to 7pm, and same-day repair is often possible. Call (855) 337-1157 to book.
What Our Chimney Repair Service Includes
Chimney repair covers the whole structure, not just the part you can see from the sidewalk. Brick, mortar, crown, flashing, flue liner and firebox all fail in different ways and on different schedules, and a repair that only addresses one of them leaves the others to keep deteriorating. Here’s what we handle in Bushwick.
Mortar Repointing
Mortar is the softer element in a brick wall by design, so it wears out first. When joints recede, crumble, or turn to sand under a fingernail, repointing restores them before the brick above starts to move. We grind out the failed mortar to a proper depth and pack new mortar in matched to the original’s composition and color, so the repair blends rather than standing out as a patch.

Spalling Brick Repair
Spalling is when the face of a brick pops off, leaving a cratered, exposed core that absorbs water fast. It usually starts with trapped moisture freezing behind a hard mortar surface, and once one brick goes, the ones around it follow. We replace spalled units with brick matched to the existing wall and correct whatever caused the moisture to sit there in the first place.

Chimney Waterproofing
Water is the leading cause of long-term chimney deterioration, and masonry is porous by nature. Waterproofing is a breathable treatment applied to the exterior that sheds rain while letting moisture inside the wall escape, so you’re not sealing water in. We apply it after repairs are done, never over failing mortar, because coating a crumbling joint just hides the problem.

Flashing Repair
Flashing is the metal where the chimney meets the roof, and it’s the most common source of chimney leaks. When it pulls away, rusts through, or was never installed with proper step and counter-flashing, water runs straight down the masonry and into the ceiling below. We reseal or replace the flashing and tie it into the roof covering so the joint actually sheds water.
Chimney Rebuilding
When damage runs past the point where patching makes sense, partial or full rebuilding is the honest answer. That usually means the top few courses above the roofline, where freeze-thaw cycles do the most work, though a chimney that’s leaning or has lost structural bond may need more. We rebuild to match the original profile and use materials suited to our local freeze-thaw pattern, and we’ll tell you plainly if a smaller repair would hold.
Tuckpointing
Tuckpointing is the finer version of repointing: joints are cut out and refilled with a contrasting mortar to create a crisp, defined line, historically used to make rough brickwork look more uniform. On Bushwick’s older facades it’s often the right choice for visible chimneys where appearance matters as much as weather-tightness. We match the mortar mix and joint profile so the result reads as original rather than applied.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Repair
We work with a portfolio of industry-vetted brands because the material inside a repair decides how long it lasts. DuraFlex flexible liner systems are part of our toolkit for relining work, and we know how those liners behave through a full heating season: where the joints need support, how they handle a chimney with an offset, and what a proper top termination looks like. HeatShield is the other system we lean on heavily. It’s a resurfacing method for restoring flue integrity without pulling the whole liner out, and it’s the difference between a repair and a demolition for a lot of older flues.
For caps, venting and structural components we work with Olympia Chimney and Famco, and Gelco and Copperfield round out the materials side of our repair work. Each of these products has its own installation requirements, and getting those right is what separates a repair that lasts from one that fails at the first hard freeze. Whether your chimney carries DuraFlex, HeatShield, Olympia Chimney, Famco, Gelco or Copperfield components, or any other make, we can help.
Signs You Need Chimney Repair Right Now
- Crumbling or recessed mortar joints. If you can dig mortar out with a screwdriver or see daylight between bricks, the joints have failed. This is the earliest and cheapest stage to fix, and it only gets more expensive from here.
- Flakes of brick on the roof or in the yard. Brick faces that have popped off mean spalling, and the exposed core soaks up water fast. Left alone, the wall keeps losing material until replacement is the only option.
- Water stains on the chimney breast or ceiling. Brown rings or peeling paint inside the house usually trace back to flashing or a failed crown. Water finds the smallest gap, and the damage inside is often worse than what you can see outside.
- A white, chalky bloom on the brick. That’s efflorescence, salt pushed to the surface by moisture moving through the masonry. It’s a sign the wall is wet, not just dirty, and it points to a waterproofing or flashing problem.
- A chimney that leans or has visible cracks running through the brick. Movement in the structure is a different category of problem. Stop using the fireplace and have it looked at before anything else; we can assess it and tell you what’s safe.
Our Chimney Repair Process – Step by Step
- 1
Book the visit and confirm the symptoms. We ask what you’re seeing and when you first noticed it, because a stain that appeared after a storm points somewhere different than one that’s been spreading for months. That shapes what we look at first.
- 2
Inspect the full system. We check the exterior masonry, crown, flashing and cap from the roof, then run a camera down the flue to see the liner’s actual condition. Photos go into the report so you’re looking at the same evidence we are.
- 3
Diagnose and explain, in plain terms. You get a clear account of what’s failing, what caused it, and what happens if it’s left. If part of the chimney can safely wait, we say so rather than rolling it into the quote.
- 4
Agree the scope and price before work starts. The written estimate sets the final price, and nothing gets added without your approval. You’ll know the materials too, whether that’s matched mortar for repointing or a HeatShield flue resurfacing.
- 5
Complete the repair and verify it. We finish the work, check it against the original diagnosis, and leave you with a record of what was done. If a follow-up inspection makes sense down the line, we’ll tell you when.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in Bushwick?
Chimney repair in Bushwick typically runs from a few hundred dollars for targeted masonry work up into the low thousands for structural rebuilding, and the spread comes down to how much has failed and how high up it sits. Repointing a section of joints is on the lower end. Rebuilding the top courses above the roofline is at the other end, because it involves staging, material matching and more labor. Waterproofing and flashing repair tend to fall in the middle.
- Mortar repointing or tuckpointing: priced by the section and joint depth, with visible chimneys costing more than ones tucked behind a parapet.
- Spalling brick replacement: priced per unit replaced plus matching work on the surrounding wall.
- Waterproofing: priced by the exterior square footage treated.
- Flashing repair or replacement: priced by the roof tie-in and how much of the existing flashing can be saved.
- Partial or full rebuild: the highest bracket, driven by height above the roofline and how far the damage extends.
What affects the price most is access. A chimney on a tall rowhouse needs different staging than one on a low building, and that shows up in the labor. The best way to avoid overpaying is to get the diagnosis before the quote, so you’re not paying for work the chimney doesn’t need. Our estimates are free, and your written estimate sets the final price. Call (855) 337-1157 for an exact quote.
Chimney Repair Near Bushwick – Our Service Area
We connect homeowners across Bushwick and the surrounding neighborhoods with local repair work, including Bedford-Stuyvesant, Williamsburg, Greenpoint, Ridgewood, Maspeth, Glendale, Fort Greene, Clinton Hill, Crown Heights, Brownsville and Prospect Heights. Travel time varies by location, but most nearby bookings land quickly, and same-day repair is often possible. If you’re just outside the list, call and we’ll confirm coverage. You can also read more about chimney repair in Bedford-Stuyvesant or chimney repair in Ridgewood.
Serving Bushwick, NY – Our Local Coverage Area
We serve Bushwick and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Repair in Bushwick
Chimney repair is fixing the physical structure and its components: brick, mortar, crown, flashing, flue liner and firebox. It’s different from a sweep, which removes creosote and clears the flue, and different from an inspection, which is the diagnosis. Most repair jobs start with an inspection so we know what actually failed before anything is touched. Call (855) 337-1157 to book one.
Most targeted repairs finish in a day, while repointing a full chimney or rebuilding the top courses can run several days depending on weather and staging. Waterproofing and flashing repair are usually quick, often a single visit. We give you a realistic timeframe with the written estimate rather than an optimistic one. Call (855) 337-1157 to talk through your job.
Typical repair pricing in Bushwick spans from a few hundred dollars for a small masonry fix up to the low thousands for a partial rebuild, with the exact figure depending on access, height and how much has failed. The written estimate sets the final price, and the estimate itself is free. You’ll see photos of the damage before any number is put in front of you. Call (855) 337-1157 for an exact quote.
Yes, we work with DuraFlex flexible liner systems and HeatShield flue resurfacing, along with Olympia Chimney, Famco, Gelco and Copperfield components. HeatShield is particularly useful when a flue has deteriorated but doesn’t need a full liner replacement, since it restores integrity without demolition. We’ll tell you which approach your chimney actually calls for. Call (855) 337-1157 to schedule an assessment.
Same-day repair is often possible when you call early enough in the day. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. We answer 24/7, so a call outside dispatch hours gets booked into the next opening. Call (855) 337-1157 and we’ll find you a slot.
We stand behind the work we complete, and warranty terms depend on the repair type and the materials used. Masonry repairs and liner work carry different expectations, so we spell those out in the written estimate rather than in vague language. If something isn’t right after the job, we want to hear about it. Call (855) 337-1157 with questions about a specific repair.
Clear access to the fireplace and the chimney breast inside, and make sure we can reach the roof or the exterior of the chimney without obstruction. If you have prior inspection reports or paperwork on the liner, have it handy. Beyond that, there’s nothing to do; we bring the equipment and the camera. Call (855) 337-1157 to confirm your appointment details.
Schedule Your Chimney Repair Service in Bushwick Today
If your chimney is showing any of the signs above, the smart move is a diagnosis before the damage spreads. We’ll inspect the full system, show you the photos, and give you a written estimate that sets the final price. No obligation, and no work recommended without evidence you can see. Call (855) 337-1157. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. You can also start with a Chimney Sweep Bushwick visit, or read more about chimney repair in our area.
Written by the team at Chimney Sweep Bushwick.