Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Glendale
If your chimney cap is loose, rusted through, or missing entirely, or the crown on top of the stack is cracked, we handle it in Glendale. A typical cap replacement here runs $185 – $340, and crown repair with a flexible coating usually lands between $375 and $850 for a single flue. We know this neighborhood block by block, from the semi-detached brick houses off Myrtle Avenue to the rentals along the 11385 corridor near Cooper Avenue. Glendale’s tightly packed rooflines mean the work is rarely simple, and local knowledge matters. Call (855) 337-1157 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Why Glendale Homeowners Call Chimney Sweep Bushwick for Chimney Cap & Crown
Glendale is a specific kind of place to do chimney work. The ridge-and-valley rooflines of the semi-detached and row houses mean our technicians are often working between adjoining chimneys, sometimes reaching a flue from a roof plane that also serves the house next door. That’s not a complication we treat as an inconvenience. It’s the normal shape of the job here, and we plan for it before anyone gets on a ladder.
What you get from us is a diagnosis before a recommendation. Every cap and crown job starts with a look at the whole stack, not just the part you called about. We can reset or coat a crown, install a custom multi-flue cap that isolates each appliance vent, or seal a shared stack properly so smoke stops migrating into a neighbor’s unit. Nothing gets proposed that we can’t show you evidence for.
Our technicians have up to 10 years of experience, and the work runs on professional-grade materials from brands like Olympia Chimney, Famco, and Copperfield, not whatever’s cheapest at a hardware store. We work clean, we work safely between adjoining roofs, and we leave you with a written record of what we found and what we did.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Glendale
Cap Installation
A new cap is the cheapest insurance your flue has against water, debris, and wildlife. In Glendale’s humid summers and freeze-thaw winters, an open flue takes on water fast, and that moisture is what starts spalling brick and rusting dampers from the inside. We size the cap to the flue, anchor it to the crown, and make sure the spark arrestor mesh is clear.

Cap Replacement
Rusted, loose, or missing caps are everywhere on Glendale’s rental stock, and a cap that’s blown off leaves the flue open to leaf debris and the neighborhood’s dense tree canopy. We pull the old cap, check the mortar around the flue for damage the failing cap may have caused, and set a replacement that actually fits. On a shared stack, we make sure the new cap keeps your flue separate from the appliance vent next door.

Crown Repair
The crown is the mortar cap at the top of the chimney, and it’s the part that takes the most freeze-thaw abuse on Glendale’s 1920s – 1950s brick houses. A cracked crown lets water straight into the stack, which is how you end up with spalling brick and rusted dampers years later. We rebuild crowns that are too far gone and repair the ones that still have life in them, using flexible sealant that moves with the masonry instead of cracking apart.

Crown Coating
When the crown is intact but showing hairline cracks, a flexible coating is the right move instead of a full rebuild. It seals the surface against water intrusion without demolition, and it’s a good fit for Glendale homeowners who want to stop deterioration before it reaches the flue. If a coating won’t hold, we’ll tell you straight rather than sell you one anyway.
Custom Cap and Multi-Flue Cap
Glendale’s shared masonry stacks are why custom caps matter here. A standard off-the-shelf cap won’t isolate each flue when two appliances vent through the same stack. We build a multi-flue cap that covers the whole crown, keeps each vent separate, and maintains proper draft for the active fireplace. That’s the difference between a cap that looks finished and one that actually stops cross-contamination.
Every one of these jobs comes through our chimney cap & crown team, with the same specialist handling the inspection and the repair.
Trusted Brands We Service in Glendale
We work with a set of professional-grade brands: Olympia Chimney for caps and venting components, Famco for structural parts, Copperfield for crown and flue materials, and DuraFlex when a flexible liner becomes part of the job. These are materials made for chimney systems, not substitutes. We don’t claim to stock parts locally, and we don’t pretend to. What we do is specify the right component, order it, and fit it properly, so a cap or crown job in Glendale is built to last rather than just to pass inspection.
Common Chimney Cap & Crown Problems We See in Glendale Homes
- Cracked crowns on old brick chimneys. Glendale’s 1920s – 1950s masonry stacks take a freeze-thaw beating every winter, and the crown cracks first. Water gets in, the brick spalls, and the damper rusts.
- Missing or loose caps on rental flues. Converted two- and three-family rentals often sit with open or half-attached caps for years. Leaf debris and animals clog the spark arrestors, and the flue is wide open to weather.
- Shared stacks that aren’t sealed between flues. When a neighbor’s appliance vents into the same stack, improperly sized or unsealed caps let smoke and odor migrate between attached units. This is the single most common problem we find on Glendale’s semi-detached blocks.
- Downdraft from bad cap geometry. A cap that’s too short, too wide, or set at the wrong height creates downdraft instead of stopping it, and you get smoke rolling back into the room on a cold start. Cap height and placement matter as much as the cap itself.
Here’s the local picture in one paragraph. Along Glendale’s dense 11385 blocks, chimneys from adjoining properties often share a single masonry stack. A cap or crown job on one flue can expose a neighbor’s appliance vent, common in rentals, to cross-contamination if that shared stack isn’t properly separated and sealed. In the older semi-detached houses, original clay-tile flues with cracked mortar crowns and loose caps let water in, causing spalling brick and rusted dampers; when a neighbor’s uncapped rental flue shares the same stack, smoke and odors can migrate through the mortar joints. A qualified sweep starts with a Level 2 inspection to map the shared flue layout, then removes the old cap, repairs or coats the crown, and installs a custom multi-flue cap that isolates each appliance vent while keeping proper draft for the active fireplace.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Glendale, NY
Here’s what cap and crown work typically runs in Glendale. A standard single-flue cap installation is usually $185 – $340, and a cap replacement on an existing flue lands in the same range. A custom or multi-flue cap built to isolate a shared stack runs $450 – $900 depending on the number of flues and the crown width. Crown repair with a flexible sealant and rebuild of damaged mortar is typically $375 – $850, while a full crown rebuild on a badly deteriorated stack can reach $1,100. Crown coating alone, for a crown that’s intact but showing hairline cracks, runs $250 – $475. The written estimate sets the final price, and we don’t recommend crown work you don’t need. Call (855) 337-1157 for a free estimate.
| Service | Typical Glendale range |
|---|---|
| Cap installation (single flue) | $185 – $340 |
| Cap replacement | $185 – $340 |
| Custom / multi-flue cap | $450 – $900 |
| Crown repair (with flexible sealant) | $375 – $850 |
| Crown coating | $250 – $475 |
| Full crown rebuild | up to $1,100 |
We Also Serve Cities Near Glendale
We work across the neighborhoods around Glendale, including Ridgewood, Middle Village, Maspeth, and Bushwick. The housing stock and rooflines are similar, but we treat each community’s chimney problems on their own terms. If you’re just outside Glendale, call and we’ll confirm whether your address falls in our service area. Same diagnostic-first approach wherever we work.
Serving Glendale, NY – Our Local Coverage Area
We serve Glendale and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Glendale
Yes, but the shared stack has to be handled carefully. A new cap on your flue needs to isolate your vent from your neighbor’s while keeping both drafting correctly, so a standard single-flue cap usually won’t do it. We inspect the shared stack first, then install a custom multi-flue cap that seals each side independently. Call (855) 337-1157 to book an inspection.
It comes down to how deep the cracks go. Hairline surface cracks and minor pitting are fine for a flexible coating, which seals the crown without a rebuild. Once the mortar is crumbling, separated from the flue, or cracked through to the brick, the crown needs repair or rebuild. We inspect first so you get a straight answer. Call (855) 337-1157 for an estimate.
Heavy fall leaf load and the neighborhood’s dense tree canopy are the main reason. Debris builds up on the spark arrestor mesh faster here than in more open suburban areas, and once the mesh is blocked the draft suffers. An annual sweep-and-check before the first heating season clears it before it becomes a problem. Call (855) 337-1157 to get on the schedule.
Yes. A capped flue that’s sat unused for years, common on Glendale’s two- and three-family rentals, still collects moisture and can develop a rusted damper or cracked crown unseen from the ground. An inspection confirms whether the flue is sound or whether the cap is hiding a problem. Call (855) 337-1157 to book one.
The materials we use most often here are Olympia Chimney and Famco caps and venting components, plus Copperfield crown and flue materials, with DuraFlex for liner work. We specify the component to the stack, not the other way around. Call (855) 337-1157 for a free estimate.
Get Your Glendale Cap and Crown Job Booked
A loose cap or cracked crown is a small problem now and a big one after a couple of winters. We diagnose first, quote in writing, and do the work with professional-grade materials. Call (855) 337-1157 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Closed Saturday.
Written by the team at Chimney Sweep Bushwick.