Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Inspection for Bushwick Homeowners
Bushwick’s housing stock is old, and a lot of it hides a problem: a flue lined with cracked clay tile, a firebox packed with creosote from years of wood burning, or a cap that came loose two winters ago and nobody noticed. You can’t see any of that from the living room, and you shouldn’t have to guess. Our technicians have up to 10 years of experience, inspect the whole system rather than just the firebox, and give you camera evidence before anyone recommends work. We diagnose before we recommend, inspection first, always. Call (855) 337-1157 to book. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Chimney Inspection Service Includes
An inspection is the diagnosis, not the sales pitch. We look at the flue, the firebox, the damper, the crown, the cap and the exterior, then tell you what we found and what, if anything, needs doing. Sometimes the answer is that everything’s fine and you’ll see us again in a year.
Level 1 Inspection
A Level 1 is the routine check you get alongside an annual sweep. We examine the readily accessible parts of the chimney and venting system, including the firebox, damper, flue interior as far as we can see, and the exterior at ground level. It’s the right call when nothing has changed since the last inspection and your system is burning normally. Most Bushwick homeowners with a working fireplace and no known problems start here.
Level 2 Inspection
A Level 2 goes further: the accessible attic, crawl space and rooftop, plus a video scan of the flue interior. You need one after a chimney fire, after a flue liner change, when you switch fuel types, when you buy or sell a home, or when a Level 1 turns up something that needs a closer look. We run the camera, walk the whole system, and write up what we found in plain language.
Level 3 Inspection
A Level 3 is what happens when the first two levels can’t answer the question, and accessing a concealed area is the only way forward. That might mean opening a wall, pulling a section of masonry, or working around a component that blocks the view. We don’t recommend a Level 3 lightly, because it means real work and real disruption. When we do, we explain exactly which area we need to open and why, before anything is touched.
Camera Inspection
A camera inspection puts a video scope down the flue so we can see the joints, the liner surface and the smoke chamber without guessing. It’s how we tell a hairline crack from a gap that’s leaking combustion gas into the house, and it’s the only honest way to check a flue that curves or offsets. You see the footage. That’s the point, and it’s why nothing gets recommended without evidence you can look at yourself.
Flue Inspection
A dedicated flue inspection focuses on the passage the smoke actually travels: liner condition, creosote buildup, blockages, and whether the flue is sized correctly for your appliance. A wood stove tied into an oversized flue drafts poorly and builds creosote faster than it should. A flue that’s been relined with a DuraFlex flexible liner gets checked for fit and connection at the top plate and the appliance collar, since that’s where problems show up first.
Real Estate Inspection
Buying or selling in Bushwick means a chimney inspection belongs on the checklist before closing, not after. A Level 2 real estate inspection documents the condition of the system so the buyer knows what they’re getting and the seller has a defensible record of what was found. We provide a written report you can hand to an attorney or agent, and we’ll tell you plainly which items are urgent and which can safely wait a season or two.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Inspection
We work with a set of professional-grade brands, and that matters at inspection time because brand knowledge changes what we look for. HeatShield is a resurfacing system, and when a flue has already been restored with it we check the bond and the surface integrity rather than treating it like bare clay tile. DuraFlex flexible liners get inspected at the seams, the top plate and the appliance connection, because a liner is only as good as its terminations. Knowing the product means knowing its failure points.
Olympia Chimney and Famco components cover caps, venting and structural pieces, and inspecting those means checking fasteners, clearances and how the cap sits against the crown. Gelco is in the mix too, and each product family has its own wear patterns that a general handyman won’t recognize. Whether you have a HeatShield-restored flue, a DuraFlex liner, an Olympia Chimney cap or any other make, we can help, and we’ll tell you what we actually see.
Signs You Need Chimney Inspection Right Now
- Creosote buildup you can see or smell. Glazed, tar-like creosote on the flue walls is fuel sitting inside your chimney, and it ignites at lower temperatures than most people expect. If it’s been more than a season since your last sweep, book an inspection before you burn again.
- Smoke spilling into the room. A fireplace that puffs smoke back into the living room is usually a draft, blockage or pressure problem, not just a cold flue. Spillage can also mean combustion gases are coming inside, which is a carbon monoxide concern, so get it checked rather than worked around.
- Water stains, rust or a crumbling crown. Moisture is the leading cause of long-term chimney deterioration, and it usually starts at the crown or cap. Rusted dampers and white staining on the masonry are signs water’s been getting in for a while.
- Loose mortar, spalling brick or a leaning stack. Masonry that’s shedding its face or shifting at the joints is a structural question, not a cosmetic one. A camera inspection and a rooftop look tell you whether it’s surface damage or something deeper.
- A chimney fire you suspect happened. Many chimney fires go out on their own and go unnoticed, leaving cracked tiles and damaged liner behind. After any suspected fire, a Level 2 inspection with camera is the standard next step, not an optional one.
Our Chimney Inspection Process – Step by Step
- 1
Book the visit and tell us what’s going on. We ask what you burn, how often, whether you’ve had smoke spillage or water intrusion, and whether the fireplace has been serviced. That shapes whether you need a Level 1, 2 or 3 before we arrive. We answer 24/7, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
- 2
Protect the room and set up. Drop cloths go down, and we lay out the tools before we start. You’ll see the camera monitor, the flashlight and the hand tools we’re using, and we’re happy to explain each step as it happens.
- 3
Inspect from the firebox up and the roof down. We check the damper, the smoke chamber, the firebox joints and the flue interior, then head to the roof for the cap, crown, flashing and stack. The two views together catch problems a single vantage point misses.
- 4
Run the camera where it counts. Any offset, curve or suspicious joint gets a video scan. We photograph what we find, including the parts that look fine, and show you the footage on the spot.
- 5
Write it up and prioritize. You get a clear report: what’s urgent, what can wait, and what we’d do about each item. We don’t propose repairs on the same visit unless you ask us to, and we’ll say plainly when work can safely wait a season.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Inspection Cost in Bushwick?
Chimney inspection in Bushwick typically runs $125 – $250 for a Level 1, and a Level 2 with a camera scan usually falls in the $200 – $450 range. A Level 3 that requires opening a wall or concealed area is priced by the scope of the access work, and we quote it before any demolition starts. Camera inspections booked on their own as a follow-up generally land between $150 and $300 depending on flue length and how many offsets we have to work around. Those are typical estimates for this market, not a fixed rate, and the written estimate sets the final price.
What moves the number: the inspection level, the number of flues, roof access and pitch, whether the flue has offsets the camera has to travel through, and whether we’re documenting for a real estate transaction. How to avoid overpaying is simple. Ask what level the inspection is and why, ask whether camera footage is included, and be wary of a quote for liner or masonry work that comes before anyone has shown you the evidence. Our estimates are free, and we don’t charge a fee to come out and look.
| Inspection type | Typical range in Bushwick | What it covers |
|---|---|---|
| Level 1 | $125 – $250 | Accessible portions, firebox, damper, exterior at ground level |
| Level 2 | $200 – $450 | Attic, crawl space, rooftop, video scan of the flue |
| Camera / flue inspection | $150 – $300 | Video scope of the flue interior, offsets, joints and liner |
| Real estate inspection | Quoted per property | Level 2 documentation and a written report for closing |
| Level 3 | Quoted by scope | Access work to reach concealed areas, plus full inspection |
Chimney Inspection Near Bushwick – Our Service Area
We connect homeowners across Bushwick and the surrounding neighborhoods with independent local chimney professionals, including Bedford-Stuyvesant, Ridgewood, Glendale, Williamsburg, Maspeth, Fort Greene, Brownsville, Clinton Hill, Crown Heights, Prospect Heights and Greenpoint. Response times depend on the day and the neighborhood, so call and we’ll tell you the next available opening. If you need a chimney inspection in the next neighborhood over, we can book that too.
Serving Bushwick, NY – Our Local Coverage Area
We serve Bushwick and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Inspection in Bushwick
A chimney inspection is a visual and, where needed, video examination of your entire chimney and venting system, from the firebox and damper up through the flue, smoke chamber, crown, cap and exterior stack. It’s a diagnosis, not a cleaning. The inspection tells you the condition of the system and whether any repair or sweep is actually needed, and it’s what should come before any work is proposed. Call (855) 337-1157 for an exact quote; estimates are free.
A Level 1 inspection usually takes 30 to 45 minutes, and a Level 2 with a camera scan typically runs 60 to 90 minutes. A Level 3 depends on how much access work is required and gets scheduled accordingly. We won’t rush a rooftop check or a camera run just to hit a clock. Call (855) 337-1157 for an exact quote; estimates are free.
Expect roughly $125 – $250 for a Level 1 and $200 – $450 for a Level 2 with a camera scan, with a Level 3 quoted by scope. The written estimate sets the final price, and the estimate itself costs nothing. We don’t add a separate fee to come out and look. Call (855) 337-1157 for an exact quote; estimates are free.
Yes. We inspect DuraFlex flexible liner installations at the seams, top plate and appliance connection, and we check HeatShield resurfaced flues for bond and surface integrity. We also work with Olympia Chimney and Famco components for caps, venting and structural parts. If you’re not sure what’s in your chimney, the camera scan will tell us. Call (855) 337-1157 for an exact quote; estimates are free.
Same-day inspections are often possible depending on the schedule that day. Call (855) 337-1157 to check. We answer 24/7. Fast dispatch, 7am-7pm, Sunday through Friday, and we’re closed Saturday.
We stand behind the inspection itself: if we missed something we should have caught, we’ll come back and look again. The report you receive is our honest read of the system, with photos and video so you can verify it. Nothing gets recommended without evidence you can see for yourself. Call (855) 337-1157 for an exact quote; estimates are free.
Clear the hearth and the floor in front of the fireplace, and make sure we can reach the damper and, if there’s one, the attic and crawl space access. Don’t burn for at least 24 hours before the visit so the flue is cool and the camera view is clean. Tell us about any past chimney fire, smoke spillage or water staining when you book, since that changes the level we recommend.
Schedule Your Chimney Inspection Service in Bushwick Today
Book a chimney inspection in Bushwick and find out where your system actually stands, with photos and video you can check yourself. Call (855) 337-1157 for a free, no-obligation estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. From inspection to repair, handled by the same specialist crew, and we’ll tell you plainly when work can safely wait.
Written by the team at Chimney Sweep Bushwick.